Please .... !!!!

Replacement projector bulb BENQ SP820

11.55  Hary Kartono  3 comments

Replacement projector bulb BENQ SP820

Supplied equipment: gloves, filter
Lamplife (hours): 2000
Performance (W): 280
Lamp type: P-VIP

Changing the lamp:
1. Turn off the projector and unplug it. Let the projector cool for at least 45 minutes. The hot lamp can burn you!
2. Find the lamp cover on the projector and remove it by loosening the screws on it.
3. Use a proper screwdriver to loosen the screws which secure the lamp inside the projector.
4. Grasp the lamp by its wire handrail or handle plate and carefully remove it.
5. At this point, always clean the projector and replace the air filter which provides air to the lamp.
6. Install the new lamp according to the aforementioned instructions in the reverse order.
7. Turn on the projector and turn the lamp operation counter to zero.

Changing a bare lamp without module:
1. Turn off the projector and unplug it. Let the projector cool for at least 45 minutes. The hot lamp can burn you!
2. Find the lamp cover on the projector and remove it by loosening the screws on it.
3. Use a proper screwdriver to loosen the screws which secure the lamp inside the projector.
4. Grasp the lamp by its wire handrail and carefully remove it.
5. At this point, always clean the projector and replace the air filter which provides air to the lamp.
6. Remove all impurities from the lamp module. If it is damaged, or if the connectors are oxidized, order a new complete module – you will thereby prevent and potential damage to the lamp or to the projector!
7. Examine and remeber in detail the method by which the lamp is fastened in the module, and the method of clamping the connectors – or mark the original connection.
8. If one of the connector parts is firmly fastened to the lamp, it will be necessary to disconnect it. Plug the cable eye to the end of the connector. The cable eye is included with the lamp.
9. Carefully remove the old lamp from the module. Wear a glove when installing the new lamp. The glove is included with the lamp. Never touch the lamp with your bare hand!
10. Insert the new lamp into the module and tighten the connectors.
11. Install the new lamp according to the aforementioned instructions in Numbers 1 to 5 in the reverse order.
12. Turn on the projector and turn the lamp operation counter to zero.

Reset the lamp counter hours of operation for the projector BENQ SP820
1. Turn on the projector
2. While the projector is on, press “MENU” to open the menu
3. Select “OPTION” in the “MENU” by pressing buttons “5 / 6”, then press “ENTER”
4. Select “LAMP TIMER” (hour counter) by pressing buttons “5 / 6”, then press “RESET” for at least 3 seconds.
5. Select “RESET” by pressing button “5”

Posted in:

3 komentar:

INFOCUS Projector try not last more than four hours each projector .INFOCUS working time should not exceed more than four hours, otherwise the projector will be in the long course of their work, emit great heat, INFOCUS projector lamp SP-lAMP-078 also have a very high internal temperature, likely to cause rapid decay lamp brightness. This is based on your HD projector to be, like calorie cold light bulbs produce less.

Therefore it is better to deal with the lamp just using its metal instance. An additional essential precaution to take is to keep the projector and the lamp at room temperature. Severe weather condition (specifically winter seasons) could be dangerous to the lamp’s life.more; lampschoice.com/?portfolio=replacement-projector-lamp-holder-fit-for-sanyo

Using cotton lint free gloves is a good way to prevent accidental contamination and usually an alcohol wipe can be used to clean the quartz/glass tube if necessary. Projector Lamp Cage Manufacturer

Posting Komentar